Fried Turkey

Designate a safe area for frying. This should be a level outdoor area, such as a driveway or patio. Place a plywood board underneath the burner if desired (to catch any oil splatters) and remove any flammable items from nearby. Set up a prep table in the vicinity, if possible, and have all necessary equipment in place and ready to go.

Determine the amount of peanut oil needed. This is imperative since too much oil can be more difficult to maintain at an even temperature, and is much more likely to boil over. If using a pre-packaged frozen turkey, place the bird in its packaging into the empty fryer. Add water to barely cover. Remove the bird. Using the thermometer as "tape," adjust the length of the bottom point of the thermometer so you have a marker for the top of the water line. That will be how much oil you will need to put into the fryer when you are ready to cook. Empty the water and dry the pot thoroughly. (Note: you can do this with a fresh bird, just be sure to dry the turkey completely before moving forward with the next steps.)

Pour the marinade through a strainer set over a deep, narrow bowl or pitcher. Dispose of sediments and herbs. Place the needle of the fully closed syringe into the marinade and slowly pull the plunger back to fill. (Note: If the syringe is a little "tight," add a bit of cooking oil or Pam to the rubber end to help it glide easier.)

With the turkey lying on its back (breast-side facing up), insert the needle into the meatiest part of the breast. Push in the plunger to release about 1-inch of marinade, then carefully pull the needle back BUT NOT OUT. Shift the needle about 45 degrees and release more marinade. The goal is to inject the marinade in a starburst pattern, from about 5 different angles.

When the syringe has been emptied into the first breast, place your index finger from your free hand over the injection point as you withdraw the needle. Gently massage this spot for a few seconds to incorporate the marinade into the turkey and to prevent any from spraying out.

Using the same process, continue injecting the marinade into the other breast, thighs, legs, and wings. Place the bird on the turkey stand, head-end facing down and rear-end pointing up. The turkey should be marinated a few hours prior to cooking but preferably the night before.

Use the metal hook to slowly to drop the marinated turkey into the fryer. The temperature of the oil will decrease to approximately 350 degrees, which is the temperature you need to maintain throughout the frying process. Monitor and adjust the heat as necessary to hold this temperature.

Cook the bird until it is crisp and deep golden brown, 3 to 3 1/2 minutes per pound, which should take 40 to 50 minutes depending on the size of the bird. The turkey is ready to remove from the oil when a meat thermometer registers 155 degrees.

Remove the fried bird to a large flat pan or tray covered in clean newspaper or paper bags. Allow the turkey to rest for 20 to 30 minutes before carving. The internal temperature should increase to approximately 165 degrees during this time.

If cooking another turkey, allow the oil temperature to increase back to 375 degrees. Repeat above process with the second turkey.

When finished cooking, allow the used oil to cool completely (overnight is best). The oil can then be filtered and pumped back into its original plastic containers and stored for up to 6 months in a cool, dry place. If disposing of the oil, check with your local waste management department and follow designated protocol.